Vereisten voor systeemgeheugen: 1 GB en hoger voor 32-bits systemen; 2 GB en hoger voor 64-bits systemen. Als uw systeem het Intel RST-stuurprogramma gebruikt, kan het lijken alsof uw schijf van 3 TB slechts 800 GB groot is. Zie ons ondersteuningsartikel over het Intel RST-stuurprogramma. Noises can be caused by mounting issues. This is due to either a high-frequency vibration in the mounting hardware or a potential drive failure. I am attempting a new installation of a bootable Serial ATA drive in my PC and it is not detected correctly

First, please see Document ID: 196169 for more information on installing drives and Document ID: 188411 about the proper drivers in Windows (though if your computer's boot drive is SATA, there should be no need for additional drivers). See also Document ID: 196169 for more information on installing drives and Document ID: 188411 about the proper drivers in Windows. It will take you through a process of several steps, including partitioning and formatting the drive. You can choose the default setting - one big partition - or choose to partition the drive into multiple different partitions, as you prefer. It will then install Windows. Lyve: Periferie-naar-cloudplatform voor massaopslag Lyve Cloud: Voordelige objectopslag, ontworpen voor de multicloud If a Serial ATA drive, installed as additional storage in your computer, was previously detected but is no longer detected, this set of troubleshooting steps will attempt to get the drive detected again, or to conclude whether the drive has failed and should be replaced.Windows Vista en nieuwerNative ondersteuning voor niet-opstartschijven van 3 TB vindt plaats met GPT-partities, wat beschikbaar is op alle systemen. If your drive is otherwise displaying a lower capacity than you believe was advertised, please see Document ID: 172191 for all relevant information. Please remember that these third-party programs do not have proprietary access to Seagate hard disk information, and therefore often provide inconsistent and inaccurate results. SeaTools is more consistent and more accurate and is the standard Seagate uses to determine hard drive failure.

Once you connect a new Serial ATA drive in your computer, there remains more to do to get your drive working. Generally, if a SATA drive is configured as the bootable drive, then the computer relies on that drive to boot the computer and to launch Windows. It is the source of most of the computer's operations. So, if the computer suddenly stops detecting the bootable drive, this will almost certainly mean that the computer will fail to boot at all. Instead, some error message will occur, and it will become obvious that a serious problem has occurred. Maak een einde aan de kosten en complexiteit van het opslaan, verplaatsen en activeren van gegevens op schaal. Keuze uit een enorme opslagcapaciteit van 500 GB tot 2 TB. Profiteer van de hoogste capaciteit in de dunste 2,5-inch harde schijf in een slanke vormfactor die systeemupgrades eenvoudig maakt.After you install a device or update a driver for a device, Windows Vista or Windows 7 may not start Open the computer case and remove the data cable from the hard drive. This will stop any power saving commands from being sent.

If the drive is detected there and the colored bar to the right is still dark blue (see figure), follow the steps to Reset the Drive Letter .

If your motherboard only supports SATA1 (1.5 Gbits/sec transfer rate) and you are installing a SATA2 (3.0 Gbits/sec) or SATA3 (6.0 Gbits/sec) drive, the motherboard may not detect the drive. There are four options in that case: For Barracuda 7200.11 drives and older, as well as certain Barracuda 7200.12 models) You can place a jumper on the drive to slow it down to 1.5 Gbits/sec, so older motherboards can support it.